How can I configure my new WRT1900AC-EU (European) router to enable use of the USB port after I have set the router to Bridge mode?
1. My cable provider's cable modem is integrated into a Cisco EPC3925 modem-router, so I set it to 192.168.1.1 as my main router. (The provider's custom interface does not let me set it to bridge mode to allow direct access to the modem.)
2. I have cascaded the WRT as a secondary router with Connection Type = Bridge mode and specified IP address as 192.168.1.2.
3. I would like to back up my laptop to a Linksys-proven USB drive but the options disappeared when I set the WRT to bridge mode and gave up on Linksys SmartWiFi.
4. The firmware is 1.1.7.159143.
If I temporarily went back to (router mode?), then configured the drive, would it still work after resetting to Bride mode?